Subscribe to Blog via Email
Join 6 other subscribersRecent Comments
- Patrick on Finished Paint and Final Assembly
- Neil Traver on Dash, Gauges and More
- Neil Traver on Clutch and Throttle Cable and Engine Wiring
- Neil Traver on Clutch and Throttle Cable and Engine Wiring
- Neil Traver on More Progress on Engine and Next Steps
Links
Categories
- Accelerator Pedal
- Accessory plug
- Air cleaner
- Alignment
- Aluminum Panels
- Battery
- Battery Box
- Battery disconnect
- Body Paint
- Brake Pedal
- Brake reservoir
- Build School
- bulb seal
- Cable
- Carpet
- Clutch Pedal
- Cockpit
- Dash
- Diode
- door
- Drive Shaft
- E-brake boot
- EFI
- Engine
- filler
- Flaring Tool
- Footbox
- Front brakes
- Front end
- Front suspension
- Fuel Filter
- Fuel Pump
- fuel pump pick-up
- Fuel System
- Fuel tank
- Gauges
- Ground strap
- Headers
- Heater vents
- heater-defroster
- hood
- Ignition
- Indicator lights
- Insulation
- J pipes
- Kit Info
- level probe
- Master Cylinder
- Mirrors
- O2 Sensor
- Oil relocation
- Panhard
- Parts
- Pedal Box
- Radiator
- Rage Gold
- Rear axle
- Rear Brakes
- Rear end
- Rear Suspension
- remote battery terminal
- Ride height
- Roll Bars
- sanding
- scoop
- seam
- Seat Belts
- Seat heaters
- seat tracks
- Seats
- Shifter boot
- Shop set-up
- Side Exhaust
- Sliders
- Speakers
- Starter
- Starter index plate
- Steering rack
- Steering Wheel
- Stereo
- Stripes
- Switches
- Transmission
- Trun signals
- Trunk
- Uncategorized
- Weatherpack
- weatherstrip
- welcome
- Wheels
- windshield
- wiper
- Wiper motor
- Wiring harness
Tags
Category Archives: Wiper motor
Electrical Checks
I chose to go ahead and check out the electrical system prior to getting all the head, visit web tail and turn lights connected. So, anorexia I went ahead and connected the battery ground and the positive cables. Immediately I … Continue reading
Pre-work for Engine-Transmission Install
When the steering rack was completed, more we noticed that we could not tighten the tie rods enough on the threaded rod ends of the steering rack to get the front end close to being aligned. So, we had to … Continue reading