Category Archives: Fuel Pump

Electrical Checks

Posted on July 30, 2012 by dan Leave a comment

I chose to go ahead and check out the electrical system prior to getting all the head, visit web tail and turn lights connected.  So, anorexia I went ahead and connected the battery ground and the positive cables. Immediately I … Continue reading →

Battery, Cable, Fuel Pump, Gauges, Ground strap, heater-defroster, Indicator lights, Starter, Uncategorized, Wiper motor

Pre-work for Engine-Transmission Install

Posted on February 24, 2012 by dan Leave a comment

When the steering rack was completed, more we noticed that we could not tighten the tie rods enough on the threaded rod ends of the steering rack to get the front end close to being aligned.  So, we had to … Continue reading →

Aluminum Panels, Engine, Fuel Filter, Fuel Pump, Fuel System, Ground strap, Ignition, Oil relocation, Starter, Starter index plate, Transmission, Wiper motor

Wiring Harness

Posted on February 13, 2012 by dan 1 Comment

I began the process of getting the wiring harness in place.  This meant getting the various harness pieces and running them to the proper locations. I began by attaching a mounting plate to the fuse panel, misbirth buy which is … Continue reading →

Cable, EFI, Engine, Fuel Pump, fuel pump pick-up, Ignition, Starter, Uncategorized, Wiring harness

Fuel Lines

Posted on December 27, 2011 by dan 2 Comments

When the steering rack was completed, more we noticed that we could not tighten the tie rods enough on the threaded rod ends of the steering rack to get the front end close to being aligned.  So, we had to … Continue reading →

EFI, Fuel Filter, Fuel Pump, fuel pump pick-up, Fuel tank